UMMD prints another lamp
Posted by the_digital_dentist
|
UMMD prints another lamp December 09, 2024 10:11AM |
PETG, 580mm tall, vase mode, 1 mm wall, 0.25 mm layers, 13+ hours (mostly while I slept)
This is what it will be when finished. 47" tall. I have to print a new clear top piece and the pieces that go into the outer "tubes", then wire the two G63 bulbs. I'll probably run wires to the top bulb through the tubes.
Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]
This is what it will be when finished. 47" tall. I have to print a new clear top piece and the pieces that go into the outer "tubes", then wire the two G63 bulbs. I'll probably run wires to the top bulb through the tubes.
Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]
Sorry, only registered users may post in this forum.