Welcome! Log In Create A New Profile


Team Replicant

Posted by cephdon 
Team Replicant
February 23, 2010 10:21AM
Just announcing my presence and getting started on this. My Wiki location is at Team Replicant.

It might take me a bit to get everything up as I get going, but hopefully not too long.
Re: Team Replicant
September 05, 2012 10:48AM
I might have an idea about the frame printing time.

if the rods weren't solid but rather pipes with support from the inside(like that #) it would only need a little amount of material compared to solid and thus take less time to print. could be too light though

maybe if you haven't thought of it yourself yet this was of some use. if not well... just an idea
Sorry, only registered users may post in this forum.

Click here to login