[SPAIN] Fully built and calibrated Prusa 2

It is fully based on LM8UU bearings, mostly Prusa Iteration 2 parts, RAMPS 1.4, Arduino Mega 1280, 12V/5A auto-voltage power supply included, GregFrost extruder, Reprap-fab.org hotend 0.5mm for 3mm filament. Aluminium bed.

The printer is brand new and it has been calibrated with Sprinter firmware (or Marlin if you prefer).

I am based in Valencia, Spain. And my preferred choice is for seller to pick it up.

También se habla Español y Catalán.

Hola,
Estoy en intersado, ¿Aún lo tienes disponible?

Hola:

Si, aún está disponible.

The printer was sold.