[US] Wade's Geared Nema 17 Extruder and Hardware

I have a few more Wade Extruders plus the hardware needed (now including bearings) for sale. This is the same setup I'm using on my Mendel. I just posted a set to eBay starting at $25 with a buy it now of $45. I also have the same parts for sale on my Etsy shop for a little less, plus I also have a listing for just the printed parts for $29. $5 shipping in the US and $15 international.

Printed Parts Included:

* OpenSCAD Geared Nema 17 Extruder Block by Lenbok
* Beefed up idle bracket for Wade's Extruder by nophead
* Gear with setscrew for Wade's extruder by nophead
* Original 39t17p gear by Wade

Hardware Included:

* 1x M3 grub screw
* 4x M4 wing nuts
* 2x M8x50 bolts (one bolt for drive screw, the other bolt can be cut for idler wheel)
* 6x M8 washers
* 2x M8 nuts
* 2x springs (needs to be cut to the right length)
* 4x M4x45 bolts
* 8x M4 washers
* 4x M3x10 bolts
* 4x M3 washers
* 3x 608 bearings

---

--
Tony Buser http://tonybuser.com * http://reprap.org/wiki/User:Tbuser#Projects

Hey do you still have a set of just plastic? LMK I need one badly........

I'm sold out at the moment, but I'll be making some more this weekend!

---

--
Tony Buser http://tonybuser.com * http://reprap.org/wiki/User:Tbuser#Projects

pm me with info and ill prepay!

Would you please email me how to order a complete set?

I ran out of some of the components and I'm waiting for more to arrive. Perhaps later this week I'll be able to start selling kits again.

---

--
Tony Buser http://tonybuser.com * http://reprap.org/wiki/User:Tbuser#Projects