The parts are printed with a 0.4mm nozzle using Ultimachine natural PLA.
Printed on heated bed with kapton tape, I didnt see warping on any of them.
Also, Ill include a set of Nopheads pullys(forgot to put them in the picture)
[
www.thingiverse.com]
And if you buy(or already have) one of wades extruder sets also,
[
forums.reprap.org]
Ill print a set of the bowden adapters to go with it.
[
www.thingiverse.com]
If you want both, I can combine shipping but I dont know what it will be yet.
I will be putting this on ebay in another post.(EDITED)
Shipping to US is $5
Shipping outside the US will be $15
PayPal Accepted
Please make sure you have a verified shipping address on file with PayPal before sending payment.
Im still getting my Mini Mendel built(waiting on motors and stuff) So if anything isnt properly designed or something, I dont know about it yet. That being said, there are at least 2 working Minis Ive seen online. If a peice or two needs to be reprinted, Ill send it out for the cost of shipping.
Edited 2 time(s). Last edit at 06/21/2010 01:10PM by RustySpoon1121.
