This Is one that I just got finished with the mechanics no plastic through it yet maybe tomorrow. Should be much sturdier than most tabletops here is a few pictures
[
one of the reasons I built this was to test that it was the mechanics that were causing a lot of the bad print problems but I really didn't know if the standard reprap electronics Arduino and the ramps 1.4 was the culprit not having enough processing power to do good prints. I'm happy to announce that it's definitely just the mechanics this Arduino and a ramps 1.4 produces good prints if the machine is sturdy enough the last picture here is a link to a bad video of it running a print after calibration
Edited 5 time(s). Last edit at 05/23/2014 07:58PM by cnc dick.