Placement of FSR Sensors

I bought an FSR kit for my Rostock Mini, though I am not sure if it is better to place the sensors near the XYZ towers or the ABC locations (?) between / opposite the towers.

I think most of the Kossel printers I have seen with FSR sensors have them at the ABC locations, though it is fairly easy to bolt them to the frame in those locations. For my Rostock, I was thinking it might be easier / cleaner to wire them near the towers, but I didn't know if this would impact performance or not.

I can't see that it would impact performance either way. The important thing is that the bed is supported only by the FSR sensors, so that wherever the head touches the bed, at least one of the sensors will have an increased force on it.

---

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].