Hi all,
I've loaded the Kossel Mini firmware onto this printer. This is a Ramps 1.4.
I have z = 0mm being the bottom position, close to the bed, and 315mm it on the top, when the 3 carriages hit the stops.
I have not been able to run a home to 0 position and have the probe go toward the bed. Additionally, when the probe is moving in the z-direction, I'm holding a metal wrench close to the inductive probe, but nothing stops.
The inductive probe red LED is always lit, partially. When I bring the metal wrench around it, I see the light be brighter, but it doesn't go from no light to light, just some light to more light.
How do we configure the 0 position? I watched a lot of videos about setting the head to be 0.2mm from the bed, but I can't seem to set the 0 position.