Welcome! Log In Create A New Profile

I'm about to finish But !!

Project O

I'm about to finish But !!
September 20, 2015 10:52PM

Registered: 8 years ago
Posts: 4

hey guys I'm about to finish my calibration.But i found out that my Z-probe not working probably due mechanical problem .
1-my first question can i print with out Z-probe in my kossel ??
because the idea is to print the broken part of the z-probe to fix it
2-if it possible how i fix that in marlin

sorry for my bad English and the question I'm a beginner grinning smiley

Reply Quote

nebbian

Re: I'm about to finish But !!
September 20, 2015 11:35PM

Registered: 8 years ago
Posts: 916

1 - Yes, no problem. I've been printing for weeks without the probe.

2 - Yes, just remove the G29 command from your slicer settings.