I am curious and look forward to this when I start to build my RoMax.
I've had some prints where z-lift would be really helpful but haven't had the time or money to get my Prusa into proper condition to use z-lift.
I'm thinking something like the Rostock design should be awesome at using z-lift without any issues. Using belts on pulleys the backlash should be minimal. Also because the same drive that controls x and y is also controlling z, I would think z lift should be pretty seamless during the printing of islands. Another advantage I see is speed, again with the same drive for all axis' I would think z-lift would have almost no affect on print speed.
Am I correct in these assumptions?
Of course this all assumes a good firmware I'd think, and we are still in the baby days of Delta firmware from what I read.
Edited 2 time(s). Last edit at 01/19/2013 10:55PM by xclusive585.