Hey 3D friends,
unfortunately I need help ones again.
My Rostock is fully assembled
Extruder and Bed are heating up quickly
Temp sensors and endstops are running good
But Rostock makes bullshit... Sometimes he's/is's homing normal, sometimes not. Sometimes he's driving smooth, sometimes Up and Down or driving 1 Axis down under the extruder ... I tried it with pronterface and repetier and got the same problems.
[
www.vidup.de]
[
www.vidup.de]
Thanks
Here are some more informations about my system:
Printer Type: Rostock MAX
Arduino 2560 (software 1.0.5) - Ramps 1.3 with 6 endstops
If you need my firmware, I'll upload it for you
Edited 1 time(s). Last edit at 08/11/2013 12:25PM by m.schmitt.