Rostock Mini - X & Y Not moving during print (video)

Thank you all for you help thus far. My Rostock Mini homes now and I'm very grateful for your help.

My issue now is that my printer is moving to print but the x and y do not work.
- The Pronterface software shows the Gcode is processing.
- The rostock homes
- The head moves to begin the print
- The extruder moves correctly
- The z axis moves correctly after each layer
- The x and y do not move after the initial parking position.

Please watch this video (skip to 2:20 to see the printer start to move) and let me know what you think may be happening.

[www.youtube.com]

As always, I've attached the Configuration.h file

Thank you in advance.

Mike

Ok, I watched the video. Keep in mind this is a delta, to move in the "z" direction all 3 motors have to move the same amount. Are you able to jog in the X and Y directions? That part looks tiny compared to your build surface, maybe try something bigger to see the motion. Care to attach your configuration.h

Edited 1 time(s). Last edit at 04/20/2014 10:06PM by jaydmdigital.

---

------------------------------------------------------------------------------
[reprapandme.blogspot.com]
[reprapandme.blogspot.com]
[reprapandme.blogspot.com]

Hi Mike

A couple of things spring to mind after a quick scan of your configuration. You don't have a thermistor defined for your hot end and the value for DELTA PRINTABLE RADIUS is set at 40, which seems very low. This value is used to set the limits for X and Y travel. I assume it should be around 80 or 90.

Andy

Andy,

You the MAN! That was it. Like other people the g code is way off of the 0, 0, 0 coordinates. I played with the software and now have the code near home. Upped my radius like you said and now it is going through the motions.

Not to reach temperature.... Starting that now.

Mike