Down to the final steps to get my printer to run. It moves, it homes, it is configured to be level. But it just wont reach full temperature!!!
This is what happens:
1-Load file
2-Pronterface slices it using Slic3r
3-I edit the g-code and remove the line for reaching bed temperature as I do not have a heated bed yet.
4-Press Print
5-The Rostock-Mini homes and parks 10mm above the surface
6-Waits for tip to reach temperature (185')
7-After 15 minutes it reaches the temperature of 175 and produces a sine wave like temperature fluctuation around +/- .4 degrees
It is as if it thinks the goal is 175 not 185.
Via g-code the printer returns the temperature of 175 so I don't think the printer thinks it is at 185.
Here is a link describing my issue, how I have configured Slic3r and Pronterface.
[
www.youtube.com]
Attached is my config files from Marlin software.