Welcome! Log In Create A New Profile

Did someone flash successfully repetier firmware 9.1 on delta printer? (arduino and ramps)

Posted by forgoden

forgoden

Did someone flash successfully repetier firmware 9.1 on delta printer? (arduino and ramps)
October 23, 2014 04:40PM

Registered: 10 years ago
Posts: 89

Did someone flash successfully repetier firmware 9.1 on delta printer?

I am using Arduino Mega 2560 and Ramps 1.4.

Send me the configuration.h please? Or post here?

Mines won't flash where I written the problem in [forums.reprap.org]

Reply Quote

3D-ES

Re: Did someone flash successfully repetier firmware 9.1 on delta printer? (arduino and ramps)
October 23, 2014 05:08PM

Registered: 10 years ago
Posts: 157

I installed Repetier 0.91 on my Minitronics,
you can find my firmware install log here.

I used Arduino 1.0.5

Hope it helps!

RS-Online Ormerod #263, Kossel mini with Minitronics, Prusa i3 MK2

Reply Quote

Kurzaa

Re: Did someone flash successfully repetier firmware 9.1 on delta printer? (arduino and ramps)
October 29, 2014 04:15PM

Registered: 9 years ago
Posts: 569

Its been awhile and I haven't been playing with my printer. But I recall having to download a different AVRDude or something like that. The compiled firmware was close to the storage limit of the 2560, so checksums were preventing a successful import of the firmware.

Sorry I can't offer anything more than that.

Reply Quote

hercek

Re: Did someone flash successfully repetier firmware 9.1 on delta printer? (arduino and ramps)
October 29, 2014 05:43PM

Registered: 10 years ago
Posts: 732

Works with Arduino Mega 2560 and Ramps 1.3.
An example config is attached.
Have a good luck.