IcePick Delta - "Pick and Place" Delta 3D Printer
Posted by DennyP
|
IcePick Delta - "Pick and Place" Delta 3D Printer February 09, 2015 08:21PM |
Hello all,
This is NOT my design, but I figured this design really deserves a big applause and a backdrop of makers building upon the design
Could be a new approach to Delta bots.
[3dprint.com]
No bearings and rods is a very nice feature.
Edited 1 time(s). Last edit at 02/09/2015 08:22PM by DennyP.
This is NOT my design, but I figured this design really deserves a big applause and a backdrop of makers building upon the design
Could be a new approach to Delta bots.
[3dprint.com]
No bearings and rods is a very nice feature.
Edited 1 time(s). Last edit at 02/09/2015 08:22PM by DennyP.
|
Re: IcePick Delta - "Pick and Place" Delta 3D Printer February 10, 2015 01:44AM |
Indeed, from what I read it was based on the Firepick design.
What I like about this one is its Reprappy nature of it all
What I like about this one is its Reprappy nature of it all
Sorry, only registered users may post in this forum.