Hi all,

My RichRap 3DR build is progressing nicely, I am about to start on the electronics. I am using a RAMPS board as I had one already and was wondering how the jumpers under the motor driver boards should be set, I read on the RepRap wiki that they should all be jumpered for 1/16 step. Is this the case with the 3DR?

Z

Bump

yes with 3dr you want full micro stepping enabled.

---

My Personal Blog. Build blog.
[engineerd3d.ddns.net]

Modicum V1 sold on e-bay user jaguarking11

Thanks for that. Hoping to have the electronics done by the weekend.

Z