Welcome! Log In Create A New Profile

Repetier Firmware not compiling for Rostock

Posted by fe1od1or

fe1od1or

Repetier Firmware not compiling for Rostock
July 09, 2015 09:02PM

Registered: 9 years ago
Posts: 18

I am using Repetier Firmware for my Rostock printer, but have run into an issue. When I go to compile it in the Arduino IDE, it gives me errors about various things not being defined/initiated. Most have to do with fastio.h. I have attached a file that has all the errors copy/pasted into it. Any insight is appreciated.

Reply Quote

Attachments:
open | download - Repetier errors.rtf (15 KB)

dougal1957

Re: Repetier Firmware not compiling for Rostock
July 10, 2015 02:22AM

Registered: 9 years ago
Posts: 1,159

I would suggest that this should be in the Repetier section that way Marcus will see it and as the author of the FW he would be best placed to answer your Question

Doug

Reply Quote

angelo

Re: Repetier Firmware not compiling for Rostock
July 10, 2015 10:19AM

Registered: 11 years ago
Posts: 1,807

Please check, if you have the -> fastio.h file in the repetierfiemware files.

The simplest method is, that you configure your Firmware Settings (look in your configuration.h) on this Webtool:
[www.repetier.com]

Download complete firmware incl. these settings // unzip it and try it.

if it is work, it is Ok. If not plese give us a feedback.

Reguards
Angelo

Mein Club: [hackerspace-ffm.de]
RADDS-Shield -> Commercial [max3dshop.org]

Reply Quote

fe1od1or

Re: Repetier Firmware not compiling for Rostock
July 10, 2015 11:21PM

Registered: 9 years ago
Posts: 18

Yes, I have the fastio.h file. Everything was set up with the online tool, so I'm surprised that it is not working. I'll put up a copy of this topic onto the Repetier one, thanks for the tip.