Folger Tech Kossel 2020 specs wanted November 12, 2015 07:00AM |
Registered: 9 years ago Posts: 11 |
Re: Folger Tech Kossel 2020 specs wanted November 12, 2015 07:53AM |
Registered: 10 years ago Posts: 14,684 |
Quote
KevinS
40mm calibration block is printing 40.4mm using 75 steps per unit.
20mm is printing 20.2mm so its a linear error which points to the step size.
Re: Folger Tech Kossel 2020 specs wanted November 12, 2015 09:23AM |
Registered: 9 years ago Posts: 11 |
Re: Folger Tech Kossel 2020 specs wanted November 12, 2015 09:39AM |
Registered: 9 years ago Posts: 445 |
Quote
KevinS
Thanks.
That's actually a big help. I found that by pushing a digital caliper down with the effector, these need to be around 81.25. It seemed to me the height was also too big but my cal object is only 10mm high so any error might be in the "noise floor"
Re: Folger Tech Kossel 2020 specs wanted November 12, 2015 05:19PM |
Registered: 9 years ago Posts: 11 |