Hi,

im gearing up to get a dual nozzle setup on my delta. I have two different hotends that might not have the same height and washers under the mounting plates might not be the most sensible tuning mechanism.

While looking for effector design I didnt find any that had an adjustment mechanism for that, so im wondering how this is supposed to be done?

Cheers

I know that this doesn't help your situation, but the chimera has grub screws to allow you to adjust the height of each nozzle. The chinese clones are about the same price as a single hotend, which means that it's a no-brainer to get one of those instead of another 'normal' hotend.

Well i thought about chimera and cyclops im just waiting for some more reports on contermination. I bought normal hotends since there are some setup issues that I need to test anyway without disturbing my original setup.

Its probably a bit finicky but if I glue nuts on the top of the effector then I can make a screw advanced space similar to the endstop adjusters.