New delta drive June 07, 2016 08:40AM |
Registered: 9 years ago Posts: 52 |
Re: New delta drive June 07, 2016 10:20AM |
Registered: 8 years ago Posts: 42 |
Re: New delta drive June 07, 2016 11:11AM |
Registered: 10 years ago Posts: 14,672 |
Re: New delta drive June 07, 2016 11:25AM |
Registered: 13 years ago Posts: 268 |
I have both the 5:1 version of that motor and the 27:1. Either fit my extruder which is direct. I did not find the 27:1 to be any improvement, if anything it was slightly worse.Quote
dc42
27:1 gearing is very high. What retraction speed and acceleration are you able to achieve? Although I guess that with a short Bowden tube on a flying extruder, fast retraction is less important.
Re: New delta drive June 07, 2016 11:45AM |
Registered: 9 years ago Posts: 2 |
Re: New delta drive June 07, 2016 04:19PM |
Registered: 9 years ago Posts: 52 |
Quote
DC42
What retraction speed and acceleration are you able to achieve?
It has loads of torque, easily enough torque for a longer bowden tube.Quote
BuildAThing
With a nema 11 motor and the 27 to 1 box would your torque be about 36 Nm? Do you think that is enough for longer bowden tubes?
Re: New delta drive June 07, 2016 10:58PM |
Registered: 8 years ago Posts: 177 |
Re: New delta drive June 07, 2016 11:06PM |
Registered: 9 years ago Posts: 52 |
Re: New delta drive August 02, 2016 07:39AM |
Registered: 8 years ago Posts: 312 |
Re: New delta drive August 02, 2016 09:44PM |
Registered: 9 years ago Posts: 978 |
Re: New delta drive August 02, 2016 10:00PM |
Registered: 9 years ago Posts: 52 |
Re: New delta drive August 11, 2016 09:28AM |
Registered: 8 years ago Posts: 3,525 |
Re: New delta drive August 11, 2016 04:32PM |
Registered: 9 years ago Posts: 52 |