Welcome! Log In Create A New Profile


Kossel xl x + - twisted

Posted by manjoel 
Kossel xl x + - twisted
November 29, 2016 04:13PM
Hallo, I have a problem. On the x direction of my Kossel - and + are twisted after an reassemble. Befor I disassembled the probe deploy and retract positions worked, after reassembeling I needed to change x coordinat to -. What could be the problem and would it be possible to print without errors with this problem

Re: Kossel xl x + - twisted
November 29, 2016 08:53PM
It's possible that your X and Y motors are swapped (assuming I understood you correctly).

Recheck that the X motor and endstop is connected to the X terminals on your board.
Re: Kossel xl x + - twisted
November 30, 2016 01:52AM
All Motors and Endstops are connected correctly on the ramp board. What's strange for me that only on the x direction - and + are twisted, but the homing is working. The only thing I change bevor reassembling it the length of the extrude Motor, -Z probe, hotend.
Sorry, only registered users may post in this forum.

Click here to login