Inconsistent Z height on Delta calibration December 01, 2016 09:56AM |
Registered: 7 years ago Posts: 83 |
Re: Inconsistent Z height on Delta calibration December 01, 2016 04:28PM |
Registered: 8 years ago Posts: 3,525 |
Re: Inconsistent Z height on Delta calibration December 01, 2016 07:20PM |
Registered: 7 years ago Posts: 83 |
Re: Inconsistent Z height on Delta calibration December 02, 2016 04:43AM |
Registered: 7 years ago Posts: 83 |
Re: Inconsistent Z height on Delta calibration December 02, 2016 10:10AM |
Registered: 10 years ago Posts: 732 |
Re: Inconsistent Z height on Delta calibration December 02, 2016 01:03PM |
Registered: 7 years ago Posts: 83 |
Re: Inconsistent Z height on Delta calibration December 02, 2016 02:45PM |
Registered: 8 years ago Posts: 3,525 |
Re: Inconsistent Z height on Delta calibration December 02, 2016 04:25PM |
Registered: 7 years ago Posts: 83 |
Re: Inconsistent Z height on Delta calibration December 02, 2016 04:29PM |
Registered: 8 years ago Posts: 3,525 |
Re: Inconsistent Z height on Delta calibration December 02, 2016 04:33PM |
Registered: 7 years ago Posts: 83 |
Re: Inconsistent Z height on Delta calibration December 02, 2016 05:21PM |
Registered: 10 years ago Posts: 14,672 |
Quote
siddharta
When reassembled I'll try the escher3d calibration routine, however, reading that I would need to sort out the issue with the limited motion range of the effector to get any useful results.
Re: Inconsistent Z height on Delta calibration December 02, 2016 05:40PM |
Registered: 7 years ago Posts: 83 |
Quote
dc42
Quote
siddharta
When reassembled I'll try the escher3d calibration routine, however, reading that I would need to sort out the issue with the limited motion range of the effector to get any useful results.
The calibration routine I published at escher3d is based on the one I wrote in RepRapFirmware. As you are running on a Duet WiFi, you are running RepRapFirmware. So if you have a Z probe, you can do the calibration automatically.
Re: Inconsistent Z height on Delta calibration December 03, 2016 03:25AM |
Registered: 10 years ago Posts: 14,672 |
Re: Inconsistent Z height on Delta calibration September 26, 2019 06:18PM |
Registered: 4 years ago Posts: 6 |
Re: Inconsistent Z height on Delta calibration September 27, 2019 02:23PM |
Registered: 10 years ago Posts: 732 |
Re: Inconsistent Z height on Delta calibration September 30, 2019 06:04AM |
Registered: 4 years ago Posts: 6 |
Re: Inconsistent Z height on Delta calibration September 30, 2019 07:06AM |
Registered: 10 years ago Posts: 732 |
Re: Inconsistent Z height on Delta calibration September 30, 2019 11:11AM |
Registered: 4 years ago Posts: 6 |
Re: Inconsistent Z height on Delta calibration September 30, 2019 12:50PM |
Registered: 10 years ago Posts: 732 |