Here is the board style I have
[
i.imgur.com]
Between this [
reprap.org] and this (really poorly translated) website [
osoyoo.com] I went in to measure the voltage.
Here's what I got [
i.imgur.com]
Every other pot gives me .565V +/- .025V except this one. It drops down to -.011V if I adjust it, but it doesn't go any higher than this.
I know that isn't right, but I'm not sure where to go from here.
FWIW, this isn't the potentiometer for the extruder that has been giving me problems, this is one of the motors for the arm pairs.
Previous thread of nonsense I had to go through for this.
[
forums.reprap.org]