Direct Drive E3D Titan extruder on Delta

Many people have wondered, so I am here to provide an answer. It works, and it works well. I don't print at high speeds (normally around 65mm/s - 80mm/s) as most materials don't perform their best when printed super fast anyway. I prefer quality over raw speed and ugly prints.

Here is my thingiverse post: [www.thingiverse.com]

And pictures:
New effector:


Everything mounted:


Overall:


I still need to mount the top MDF plate so I can have the filament spools up there.

Edited 2 time(s). Last edit at 01/28/2017 11:39AM by MrBaz.

I thought about doing that for my Kossel, considering that I use a Volcano, and can output more volume compared to a smaller hot end, moving at the same speed.