I am running a azteeg x5 mini and I cant seem to get the endstops working properly. With M119 I can test all my end stops and they seem to be all working; when I home (G18), it seems like the software does not recognize the endstops at all and keeps the motors going.

Attach your config and we might be able to see what's wrong.

I thought it was the wrong pin out but I checked with the axteeg x5 mini and it should be right.

Hmm that config seems OK to me. The only difference with my config that might make a difference is the 'alpha_limit_enable' set to true on yours, mine doesn't have those lines (for alpha, beta and gamma). Try removing those lines (or set them to false).


Also you can try this: turn the machine on, and jog in Z in +1mm increments. Do your carriages go up or down? If they go down for +Z movements then you might have the issue below.

It's possible that you might have a combination of:
1) Wrong direction on motors, and
2) Endstops are not inverted.