Hello
I would like to build an Anycubic Kossel Plus Linear auto-leveling with a new frame.
Everything should be built from the Anycubic Plus in the new frame.
It will be a Pentachoron - Delta 3D Printer.
Link: Hello
I would like to build an Anycubic Kossel Plus Linear auto-leveling with a new frame.
Everything should be built from the Anycubic Plus in the new frame.
It will be a Pentachoron - Delta 3D Printer.
Link:
https://www.instructables.com/id/Pentachoron-Delta-3D-Printer-With-Auto-Bed-Levelin/
This should be a bit bigger with the option of a bigger printbed later.
The original carbon rods from the effector should be extended. But how do I know exactly how long?
How exactly do I calculate the length I need?
Can I just take over the measurements in the instructions for the frame or do I have to pay attention to what?
Edited 1 time(s). Last edit at 10/17/2018 03:51PM by PhoenixPegasus.
