|
Re: Delta printer ball joints, let's talk! December 25, 2019 04:00AM |
Registered: 6 years ago Posts: 14,389 |
If your printer runs RepRapFirmware then small differences in scale can be corrected using M579.
Large delta printer [miscsolutions.wordpress.com], Robotdigg SCARA printer, Crane Quad and Ormerod
Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Large delta printer [miscsolutions.wordpress.com], Robotdigg SCARA printer, Crane Quad and Ormerod
Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
|
Re: Delta printer ball joints, let's talk! December 25, 2019 06:08AM |
Admin Registered: 7 years ago Posts: 2,784 |
Okay, I will start a new topic that is specific to this printer so it's easier to get some help instead of replying under other's topics.
http://www.marinusdebeer.nl/
http://www.marinusdebeer.nl/
Sorry, only registered users may post in this forum.