K200 HE3D with Rumba Board

Hello


Is there anyone here who can help me create a firmware for the Rumba board and the HE3D K200?
I would like 3 extruders and a heating bed.

Unfortunately I'm not the professional software engineer, so it would be nice if I only had to flash the firmware on the board.

Thank you very much

I'm not sure what exactly you're looking for, someone to configure Marlin for that printer?
If it's not too late, I'd earnestly recommend a 32-bit board instead of the Rumba.
Also, I hope you have some experience. 3 color/material on a delta isn't going to be easy. I'd get it running as a single extruder then dual before attempting a 3 extruder system.

Hi


Yeah, I can't do that myself, so it would be nice if someone would do that for me.
Two extruders would also be enough for me.
The LCD is a 2004A.



Thanks

Edited 1 time(s). Last edit at 12/05/2019 03:23PM by Modellelmi.

You'll probably have to find someone with that printer and a rumba board, so your chances are not good. I certainly can't help. I've only set up marlin once so I'm no expert. Not to mention I wouldn't try without the printer on hand for testing.

Perhaps you could use Repetier. There is an on-line configuration tool that you can use. It's prettly thoroughly explained so you might find you can do it yourself. There might be something similar for Marlin. I don't know.

Good luck!

Hi jcs

ok thanks.


Regards