OK - I've painted myself into a corner. I've been fiddling with the gcode associated with my Anycubic Kossel Linear Plus delta to try and get rid of a persistently annoying error, and I've managed to screw it all up. No backups of the old code, of course...
All I'd like is for someone to show me their gcode for start, finish, pause, resume, and kill. I can then compare it with what I've got and try to work out where I've gone wrong.
I'm running the following:
Repetier-Host V2.1.6 with either of the following slicers:
Slic3r v1.3.1
Cura (can't get version from R-H)
Trigorilla board with Marlin 1.1.9
Thanks in advance for any guidance...
UPDATE: I think that I've found out where I'm going wrong, so I'll close this request down.
Edited 1 time(s). Last edit at 12/15/2020 04:18AM by David J.
