Video and firmware for Marlin 1.1.9 Anycubic Kossel autocalibrate
Posted by DragonFire
|
Video and firmware for Marlin 1.1.9 Anycubic Kossel autocalibrate April 13, 2021 05:59PM |
[www.youtube.com]
As supplied, the firmware has non A4988 XYZ drivers and a heated bed. It's not too hard to change this.
It's also for pulley or linear versions, if you have a Linear Plus the radius and rod lengths etc will need changing to Plus sizes.
But it worked. For me.
As supplied, the firmware has non A4988 XYZ drivers and a heated bed. It's not too hard to change this.
It's also for pulley or linear versions, if you have a Linear Plus the radius and rod lengths etc will need changing to Plus sizes.
But it worked. For me.
Sorry, only registered users may post in this forum.