Welcome! Log In Create A New Profile


Printer crashes in the Drivebelts

Posted by Isembor 
Printer crashes in the Drivebelts
April 27, 2021 04:05PM
Hello ,

So the Titel says it all. My Anycubic Kossel Delta Printer keeps Crashing in my Drive Belts while Printing and Probing.
I am using an anycubic kossel with an skr. 1.4 Turbo Mainboard and 2208 TMC Stepper Drivers.
With a PROBING_MARGIN of 50 it stops crashing while Probing but then Printing it still Crashes,
and Changing the DELTA_PRINTABLE_RADIUS and the DELTA_RADIUS not seems to change anything.

So i am again in search for some help.
I attached my Config File to this Post.spinning smiley sticking its tongue out
open | download - Configuration.h (94 KB)
Re: Printer crashes in the Drivebelts
April 28, 2021 08:41PM
I don't know if this would cause your problem or not but this section in your config is suspect:

#define X_DRIVER_TYPE 2208
#define Y_DRIVER_TYPE 2208
#define Z_DRIVER_TYPE 2208

I think it should be
#define X_DRIVER_TYPE TMC2208
#define Y_DRIVER_TYPE TMC2208
#define Z_DRIVER_TYPE TMC2208

Another thing I noticed is that your XYZ_PULLEY_TEETH is set to 16 yet the example configs is set to 20. You might want to verify what you have on your printer.
Re: Printer crashes in the Drivebelts
April 29, 2021 04:26PM
okay , thank you for your Answer.smiling smiley
It looks like it works now.smiling smiley
open | download - Configuration.h (94 KB)
Sorry, only registered users may post in this forum.

Click here to login