Welcome! Log In Create A New Profile



Posted by formulavee 
May 06, 2014 10:08AM
What is a firmware that is simple to use and basic that I can upload to a Atmega 1284p on a Gen 7 1.5 for use as a simple 3 axis mill?

I am new to programming and have been having problems with teacup,marlin and sprinter on the ardunio IDE

got the boot loader uploaded with the USBASP and the test firmware working

Any help would be much appreciated spinning smiley sticking its tongue out

Edited 1 time(s). Last edit at 05/06/2014 10:10AM by formulavee.
Re: firmware
May 06, 2014 07:44PM
Have you tried the Repetier web config tool for building custom firmware?

Re: firmware
May 07, 2014 04:01AM
Re: firmware
May 07, 2014 04:55AM
I have had a go at grbl but I couldn't get it to work. I loaded up repetier and when it went to compile it gave me this....

Any help would be fantastic spinning smiley sticking its tongue out
Re: firmware
May 07, 2014 04:59AM
Teacup is the smallest and fastest firmware. It doesn't have as many features as Marlin or Repetier, but has worked out essential stuff more carefully. Accordingly you get movements always respecting physics and up to 3 times higher step rates than e.g. Repetier.

Generation 7 Electronics Teacup Firmware RepRap DIY
Sorry, only registered users may post in this forum.

Click here to login