Welcome! Log In Create A New Profile


Ninjaflex - Heated Bed?

Posted by ByteSlinger 
Ninjaflex - Heated Bed?
April 18, 2016 08:18AM
I'm looking to print with Ninjaflex on my Fisher but wanted to check peoples opinions/experiences printing it without a heated bed.
Am I going to run into endless problems or should it be ok?
Re: Ninjaflex - Heated Bed?
May 17, 2016 02:11AM
You must squeeze it very well on the bed and print the first layer slowly, but it is definitely doable, at least on glass + PVA glue.
Re: Ninjaflex - Heated Bed?
May 14, 2018 09:28PM
We have printed with TPU filament last week, the material is similar as nanjaflex. Hot bed is helpful for the adhesive with first layer. The speed need to be much lower, about 30 mm/sec
Sorry, only registered users may post in this forum.

Click here to login