Welcome! Log In Create A New Profile


Dual-arm SCARA robot

Posted by hexan 
Dual-arm SCARA robot
June 04, 2014 10:15AM

Do you think this dual-arm SCARA robot could be used for 3D printing: [youtu.be].


Re: Dual-arm SCARA robot
June 04, 2014 02:15PM
It has a singularity to program around in the centerline. It has a bar in the way for filament overhead. If using only half of the area to remove these problems, it becomes similar to other 3D printer mechanisms like Wally and others. So, my answer is no for the configuration shown in the video, plus, the MSRP is $7K for what was shown.
Re: Dual-arm SCARA robot
June 05, 2014 12:34PM
Its been around for years


Sorry, only registered users may post in this forum.

Click here to login