Quote 691175002
I've been working on a blog but the updates have been quite sporadic. Eventually I'll review all the posts and turn it into a proper build log.
I browsed your site and actually found the printed bellows to be very interesting, as in my experience custom bellows tend to be expensive and hard to source. Lasers are fun but I hope to never find myself in a situation where an interferometer is necessary.
Can you tell me if the Parker ViX drive causes any sort of audible noise from the linear motors? I can't get the IONI to be quiet.
The baseline ambient noise is a low-rpm 120mm fan, and the servos are barely audible above that. There is a very mild hum at rest which gets overpowered by the bearings and other moving parts in motion. I would describe the servos as mostly silent.
The baseline ambient noise is a low-rpm 120mm fan, and the servos are barely audible above that. There is a very mild hum at rest which gets overpowered by the bearings and other moving parts in motion. I would describe the servos as mostly silent.
