Arcus3D-C1 3D printable, open source, tripod kinematics, cable printer
Posted by darenschwenke
|
Arcus3D-C1 3D printable, open source, tripod kinematics, cable printer October 07, 2017 08:50PM |
Been working on a new 'what can I build with these leftover parts' printer.
It seems to be turning out well.
It is a 3D printable variation on the Flying Skydelta with the steppers relocated to minimize the offset and error from wrapping, and you can remove the vertical rods for 'flat packing'.
The whole frame will cost you ~$9 as it's made from driveway markers.
Planned on using Machinekit/tripodkins on a BBG, but not very far on the configuration yet.
Open source project modeled in OpenSCAD. Source and more pictures/video here:
https://hackaday.io/project/26938-arcus-3d-c1-cable-printer
Edited 2 time(s). Last edit at 10/08/2017 07:51PM by darenschwenke.
It seems to be turning out well.
It is a 3D printable variation on the Flying Skydelta with the steppers relocated to minimize the offset and error from wrapping, and you can remove the vertical rods for 'flat packing'.
The whole frame will cost you ~$9 as it's made from driveway markers.
Planned on using Machinekit/tripodkins on a BBG, but not very far on the configuration yet.
Open source project modeled in OpenSCAD. Source and more pictures/video here:
https://hackaday.io/project/26938-arcus-3d-c1-cable-printer
Edited 2 time(s). Last edit at 10/08/2017 07:51PM by darenschwenke.
|
Re: Arcus3D-C1 3D printable, open source, tripod kinematics, cable printer October 14, 2017 08:18PM |
Added virtual pulleys to the end effector to physically cancel the error from the upper pulleys.
Featured on hackaday.
This 3D Cable Printer Remixes the Delta
Edited 1 time(s). Last edit at 10/14/2017 09:18PM by darenschwenke.
Featured on hackaday.
This 3D Cable Printer Remixes the Delta
Edited 1 time(s). Last edit at 10/14/2017 09:18PM by darenschwenke.
Sorry, only registered users may post in this forum.