Self made 3d printers - open source or commercial? Two 3d printers in one case October 18, 2017 03:22PM |
Registered: 6 years ago Posts: 12 |
Re: Self made 3d printers - open source or commercial? Two 3d printers in one case November 04, 2017 02:43AM |
Registered: 6 years ago Posts: 14 |
Re: Self made 3d printers - open source or commercial? Two 3d printers in one case November 04, 2017 06:29AM |
Registered: 11 years ago Posts: 5,780 |
Re: Self made 3d printers - open source or commercial? Two 3d printers in one case November 04, 2017 06:40AM |
Registered: 6 years ago Posts: 12 |
Re: Self made 3d printers - open source or commercial? Two 3d printers in one case November 04, 2017 08:15AM |
Registered: 7 years ago Posts: 270 |
Re: Self made 3d printers - open source or commercial? Two 3d printers in one case November 05, 2017 02:15AM |
Registered: 6 years ago Posts: 12 |
Quote
newbob
Have you looked at Klipper firmware? It's still in development and since recently has a feature to control multiple controller boards. You'll need to add raspberry pi to your setup. It's not a drop in solution but I think it would the most cost effective and high performance.
Here's thread with more info:
http://forums.reprap.org/read.php?147,667655,page=6