Welcome! Log In Create A New Profile

Advanced

Slicer timings going wrong!!

Posted by saintofinternet 
Slicer timings going wrong!!
January 05, 2018 12:25AM
hello,

i am using the Repetier Host with Slicer.... and when it shows a job completeion timing to be 2 hours 30 mins the job actually gets over around 3 hours 40 mins...

totally confused....

why would this be happening??
Re: Slicer timings going wrong!!
January 05, 2018 12:30AM
Because the assumed acceleration and jerk are different from the acceleration and jerk in your printer's configuration.


Son of MegaMax 3D printer: [www.instructables.com]
Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]
Re: Slicer timings going wrong!!
January 05, 2018 01:14AM
well... this did not happen earlier.... it has started doing this since the Repetier software got upgraded...
Re: Slicer timings going wrong!!
January 05, 2018 02:33AM
people keep changing the estimation because people keep complaining that its never right...

It will never be correct unless you actually do a emulated run on the entire gcode emulating all machine settings.
This will of course take time and people don't want to wait either
Sorry, only registered users may post in this forum.

Click here to login