Welcome! Log In Create A New Profile


Filament Run Out - Marlin Config

Posted by hello_tom 
Filament Run Out - Marlin Config
April 11, 2022 02:26AM
Good Morning everybody,

finally I got the time to set up a filament run out sensor, but ...

I used the Z-Max Endstop PINS and changed it in Marlin. When I run a M119 to see the status of the enstop, I find the 3x Min Endstops and the filament. When I m changing manually the status of the filament Input I see the movement with my M119 command.

I enabled the runout sensor and advanced pause mode feature in Marlin as well. .... but when I do a test print and simulate the filament end, nothing happens.

I working with a RAMPS 1.4 and Arduino, Marlin Version

I m lost and don t know what as to do?


Re: Filament Run Out - Marlin Config
September 13, 2022 08:15AM
Thank You very much
Sorry, only registered users may post in this forum.

Click here to login