First working reprap in NJ?
Posted by Buback
|
First working reprap in NJ? January 12, 2011 08:24PM |
I doubt I've got the first, but i am the first to report here, or at the RUG wiki page, that i am now up and printing!
Now i have to start using skeinforge. i've been using repsnapper to generate gcode, but i think that i've read that i can get better prints with skeinforge because i can fine tune it.
ps. i can't print out any parts for anyone yet, so please don't ask, yet.
Now i have to start using skeinforge. i've been using repsnapper to generate gcode, but i think that i've read that i can get better prints with skeinforge because i can fine tune it.
ps. i can't print out any parts for anyone yet, so please don't ask, yet.
|
Re: First working reprap in NJ? May 03, 2011 02:10PM |
We had a few working in early 2010, and I sold parts for another 8-10 of them. Hell, our Mendel even won Editor's Choice at MakerFaire.
So yeah, we're around.
So yeah, we're around.
Sorry, only registered users may post in this forum.