Help with Prusa i3 serial connection
September 23, 2017 10:37PM
Hi all,

I am having trouble getting my Prusa i3 to work. I have successfully uploaded the firmware, but when I connect to Repetier Host, it tells me that the start signal is not found, and then communication time out. The same thing happens if I use Pronterface. I have checked the following:

Made sure program settings and firmware have same baud rate of 115200

Correct com port (the one that shows up when I connect the printer)

I am not sure what I am doing wrong? How do I fix this?
Sorry, only registered users may post in this forum.

Click here to login