Welcome! Log In Create A New Profile

Reprappro huxley, setting e steps

Posted by smartdev

smartdev

Reprappro huxley, setting e steps
February 10, 2013 05:57AM

Registered: 11 years ago
Posts: 11

Ok, I have been trying to fine tune my esteps as the extruder pulls in just under the required ammount. I trued the command M92 Exxx as per the wiki and this did not seem to change anything. I have also tried editing the value in the firmware, though this was set to 875 but the wiki said the default is 980 any ideas?

Reply Quote

smartdev

Re: Reprappro huxley, setting e steps
February 10, 2013 07:48AM

Registered: 11 years ago
Posts: 11

ok seemed to have fixed it I altered the e steps based on the assumption that it was set to 980 even though it said 875, and it seems to have worked smiling smiley