Welcome! Log In Create A New Profile


Huxley bed thermistor

Posted by paulnd 
Huxley bed thermistor
February 16, 2014 04:16PM

What bed thermistor is shipped with new Reprappro Huxleys?

I've compiled a Marlin branch with "8 is 100k 0603 SMD Vishay NTCS0603E3104FXT (4.7k pullup)" as the bed sensor but the temperature readings are about 10°C too low, I have uploaded the Huxley firmware again and it reads correctly so it's not a wiring problem.

I have attached the configuration.h file and will be grateful for any suggestions or assistance.


Edited 2 time(s). Last edit at 02/16/2014 04:33PM by paulnd.
open | download - Configuration.h (29.1 KB)
Re: Huxley bed thermistor
February 16, 2014 04:38PM
Might be my mistake you are following I got, "NTCS0603E3104FXT" from [github.com]
Maybe that comment is wrong, I'll see if the value 4100 can shed some light.

NOTE: Looked at your Configuration.h file, looks like you have entered 10 both for hotend and bed.

Edited 1 time(s). Last edit at 02/16/2014 04:41PM by epatel.
Sorry, only registered users may post in this forum.

Click here to login