Huxley bed thermistor

Hello,

What bed thermistor is shipped with new Reprappro Huxleys?

I've compiled a Marlin branch with "8 is 100k 0603 SMD Vishay NTCS0603E3104FXT (4.7k pullup)" as the bed sensor but the temperature readings are about 10°C too low, I have uploaded the Huxley firmware again and it reads correctly so it's not a wiring problem.

I have attached the configuration.h file and will be grateful for any suggestions or assistance.

Paul

Edited 2 time(s). Last edit at 02/16/2014 04:33PM by paulnd.

Might be my mistake you are following I got, "NTCS0603E3104FXT" from [github.com]
Maybe that comment is wrong, I'll see if the value 4100 can shed some light.

NOTE: Looked at your Configuration.h file, looks like you have entered 10 both for hotend and bed.

Edited 1 time(s). Last edit at 02/16/2014 04:41PM by epatel.