Welcome! Log In Create A New Profile


[Solved] heater pinouts not working

Posted by 3D2B 
[Solved] heater pinouts not working
January 02, 2012 09:12AM
I have a ramps 1.4 board + arduino clone, supplied pre built from Reprapworld.
I'm not getting any power out from the extruder heater pins to feed the power resistor.
Am I right in that there should be a green LED lit when the extruder heater is working?


ok have sorted this one.

Edited 1 time(s). Last edit at 01/02/2012 11:11AM by 3D2B.

Prusa Mendel /Parcan Mk 2/1280 RAMPS 1.4/PC XP OS/Pronterface/Slic3r

In the UK, down south & over to the left you'll find the West of England RUG.
For details, visit tiny.cc/woereprap or tiny.cc/woerug
Sorry, only registered users may post in this forum.

Click here to login