Welcome! Log In Create A New Profile


1 test big print

Posted by michel pet 
1 test big print
January 12, 2012 10:06PM
this is my home build big print.
first test x and y .
4.8ncm motor.
sd card.
24 volt dc

now i have to vigor out Ho to setup the software its to fast.


Edited 2 time(s). Last edit at 01/12/2012 10:22PM by michel pet.
Re: 1 test big print
January 13, 2012 03:21PM


geting beter 300mm s but stil not ok.

Edited 1 time(s). Last edit at 01/13/2012 03:22PM by michel pet.
Re: 1 test big print
February 12, 2012 05:48PM
Max feed rates can be set in the firmware, what firmware are you using?

print speeds are set in the slicing software. If you are using skeinforge, lower your feedrate and flowrate to 20mm/s for both to start. Then get faster once you have nice prints. Travel speed can be as fast as the machine will take, I'm using 50mm/s just to be safe.

As long as the heater on your extruder can keep up, and you don't miss steps, you can set your feed and flowrates as high as you want.
Re: 1 test big print
March 18, 2012 11:31PM
i use repetier firmwa

my firtst print.

Sorry, only registered users may post in this forum.

Click here to login