Can someone send Sprinter file for RAMPS 1.3 please?

Dear All,

I am having problems finding a usable Sprinter file
to upload to my RAMPS 1.3 board via a Mega 2560

as I just get error messages: it could be my computer
MaCbook Air /10.8 or my Dell laptop on XP
or version of Arduino (v1.01)

I have been using a Sanguino with a pre loaded Marlin file
but I'm trying to test problems with Z home on another board

I don't have SD card or LED just XYZ and extruder motor
so if anyone has a working Sprinter file I would be very grateful

If that doesn't work then I know its my PC/Arduino or something else
Many Thanks
Simon

Use Arduino 22.

---

Help improve the RepRap wiki! Just click "Edit" in the top-right corner of the page and start typing. Anyone can edit the wiki!

Quote

as I just get error messages

Quoting error messages instead of trying to interpret them is always a good idea. We have no magic crystal ball here to see what you're doing and what you're seeing.

---

Generation 7 Electronics	Teacup Firmware	RepRap DIY

Thanks for the replies: I got a number of error
Messages which went away when I used Arduino
022 - doh!