nema 14 ramps 1.4
Posted by tom wal
|
Re: nema 14 ramps 1.4 December 01, 2019 03:31PM |
Please read https://reprap.org/wiki/Stepper_wiring
Once you have worked out the coil wiring then attach to stepper driver modules like so
The 2B 2A 1A 1B pins are the same 4 pins as used on a ramps.
NB these small steppers can be burnt out with to much current.
Make sure you set you vref for your stepper driver
Edited 1 time(s). Last edit at 12/01/2019 08:52PM by Dust.
Once you have worked out the coil wiring then attach to stepper driver modules like so
The 2B 2A 1A 1B pins are the same 4 pins as used on a ramps.
NB these small steppers can be burnt out with to much current.
Make sure you set you vref for your stepper driver
Edited 1 time(s). Last edit at 12/01/2019 08:52PM by Dust.
Sorry, only registered users may post in this forum.