Voltage drop cause print job to stop

Hello, I build a 3d printer. It works fine in normal use but when I turn on Air Conditioner (AC) in my house. There is voltage drop seen in house. Which as a result cause voltage drop on 3d printer for few seconds and if I am printing during that time the print job stops where it was when voltage dropped as if someone turn off and then on the printer and up ruining the printing object. I am using 12 volt power supply. Therefore I would like your feedback on it, what should I do.

Thank you

Edited 1 time(s). Last edit at 08/10/2020 02:14PM by Abdul Mannan.

... avoid using the AC when printing or install an UPS for your printer ...

---

Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]

Wouldn't it be possible to make some kind of power buffer that, for a short while keeps the energy going like something with supercaps?

---

http://www.marinusdebeer.nl/

... this stands an UPS for

---

Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]

Quote
VDX
... avoid using the AC when printing or install an UPS for your printer ...

I agree a UPS should eliminate the spike therefore the 3D Printer should continue without your AC power on Failure..

---

Computer Programmer / Electronics Technician