Building a second machine and its about time to try to make things move.
When I do a M119 I get either all open or triggered (this with a few jumpers right on the board)
Pullups are enabled.
I've tried:
const bool X_ENDSTOPS_INVERTING = false
const bool X_ENDSTOPS_INVERTING = true
one results in all open other all closed (with a few jumpers installed)
I've wired NC & NO
Measuring the pullups I'm getting .6DVC, just enough to create a logic 1
Temps don't show (100K resistor from bed plugged into the extruder pins, and running a heat gun shows no change.)
Since all is ka-put, I'm thinking its here:
// 3 = MEGA/RAMPS up to 1.2 = 3
// 33 = RAMPS 1.3 (Power outputs: Extruder, Bed, Fan)
// 34 = RAMPS 1.3 (Power outputs: Extruder0, Extruder1, Bed)
// 7 = Ultimaker
I'm on 7(default), should it be 33, 34? (or on the outside 3?)
TIA